Tannoy CMS6 TDC Assembly Instructions

C M S 6 T D C
M O D E L W I T H T R A N S F O R M E R
( S E E F I G . 2 )
The RED and BLACK wires are connected
to the transformer as follows:
The BLACK lead to the transformer
primary "common" lead. The RED lead is
connected to the desired wattage tap.
W I T H O U T T R A N S F O R M E R
The RED wire connects to the crossover
terminal with the red dot. (Positive termi-
nal). The BLACK lead connects to the
unmarked terminal. (Negative terminal).
F I
1
3
MOUNTING FLANGE DIA.
3 3 5 G A G E A V E N U E , S U I T E 1 , K I T C H E N E R , O N T A R I O C A N A D A N 2 M 5 E 1
P H O N E 5 1 9 7 4 5 1 1 5 8 • F A X 5 1 9 7 4 5 2 3 6 4 • E - M A I L : i n q u i r i e s @ t a n n o y n a . c o m
A S S E M B L Y
G U R E 1
CAN DIA.
11 / " 300mm
7
8
13 " 335mm
/
1
4
I N S T R U C T I O N S
I N S T A L L I N G T H E S P E A K E R / S U B
P L A T E A S S E M B L Y
After connecting the RED and BLACK
leads to the speaker/sub assembly can
be attached to the enclosure.
Fasten the sub plate to the enclosure by
inserting the silver screws in the holes
labeled 1, 2, 3, and 4, as shown on Fig. 1.
The four remaining holes are used to
fasten the grille to the enclosure. Use the
white painted screws provided. Do not
over-tighten screws. Removable locktite
on these screws is recommended.
Note: A tile bridge is required for most
applications.
F I
2
4
12" 305mm
HOLE
CUT OUT DIA.
G U R E 2
TO BOX INSTALLED
7 /
5
8
194 mm
MOUNTING
FLANGE
EXTENSION
/ " 1 1.5 mm
7
16
9 / "
5
8
246mm
"
CAN