Table of Contents
Advertisement
Inspect the card module carton for obvious damage. Shipping and
handling may cause damage to your module. Be sure there are no
shipping and handing damages on the module before processing.
After opening the card module carton, extract the system module and
place it only on a grounded anti-static surface component side up.
Again inspect the module for damage. Press down on all the socketed
IC's to make sure that they are properly seated. Do this only with the
module place on a firm flat surface.
Note: DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN
DAMAGED.
You are now ready to install your PCI-9113A.
2.3
Hardware Installation
Hardware configuration
The PCI cards (or CompactPCI cards) are equipped with plug and play
PCI controller, it can requests base addresses and interrupt according
to PCI standard. The system BIOS will install the system resource based
on the PCI cards' configuration registers and system parameters (which
are set by system BIOS). Interrupt assignment and memory usage (I/O
port locations) of the PCI cards can be assigned by system BIOS only.
These system resource assignment is done on a board-by-board basis.
It is not suggested to assign the system resource by any other methods.
PCI slot selection
The PCI card can be inserted to any PCI slot without any configuration for
system resource.
Installation Procedures
1.
Turn off your computer
2.
3.
4.
5.
8
Installation
Turn off all accessories (printer, modem, monitor, etc.)
connected to your computer.
Remove the cover from your computer.
Setup jumpers on the PCI or CompactPCI card.
Select a 32-bit PCI slot. PCI slot are short than ISA or EISA
Advertisement
Table of Contents
