HP Integrity BL860c i2 Quickspecs page 30

QuickSpecs
Memory
DIMM installation guidelines:
1. All DIMMs must be DDR3 registered memory modules (R-DIMMs)
2.
Both DIMM slots in a memory bank must be populated. A memory bank in this case is identical with a memory pair. A PCU will
drive banks A through F.
3.
Banks must be populated in sequential Alphabetic order, starting with bank A for CPU0, followed by bank A for CPU1, etc.
4.
Both DIMMs in a memory bank must be identical.
5.
DIMMs must be installed in decreasing capacity with the largest DIMMs installed in the smallest numbered DIMM slot.
HP Integrity BL860c i2 Server Blade
Standard Memory
8 GB Registered PC3-10600 DDR3 1333MHz ECC DIMMs (2 x 4 GB)
Memory Bus Bandwidth: 4.8GT/s
Standard Memory Plus Optional Memory
Up to 384GB of DDR3 registered memory is available.
Following are memory options available from HP:
HP Memory HP BL8x0c i2 4GB (2x2GB) PC3-10600 Registered CAS 9 Memory Kit
HP BL8x0c i2 8GB (2x4GB) PC3-10600 Registered CAS 9 Memory Kit
HP BL8x0c i2 16GB (2x8GB) PC3-10600 Registered CAS 9 Memory Kit
HP BL8x0c i2 32GB (2x16GB) PC3-8500 Registered Memory Kit
NOTE: Must be installed in pairs.
NOTE: DIMMs must be installed in decreasing capacity with the largest DIMMs smallest
numbered slot.
DA - 13624 Worldwide — Version 19 — April 18, 2014
HP Integrity BL860c i2 Server Blade
AM326A
AM327A
AM328A
AM363A
Page 30