Telnet; Telnet Commands; Telnet Commands Examples - ZyXEL Communications UAG Series Cli Reference Manual

Chapter 33 System Remote Management

33.5 Telnet

You can configure your UAG for remote Telnet access.

33.6 Telnet Commands

The following table describes the commands available for Telnet. You must use the
command to enter the configuration mode before you can use these commands.
terminal
Table 121 Command Summary: Telnet
COMMAND
[no] ip telnet server
[no] ip telnet server port <1..65535> Sets the Telnet service port number. The
ip telnet server rule
{rule_number|append|insert
rule_number} access-group
{ALL|address_object} zone
{ALL|zone_object} action
{accept|deny}
ip telnet server rule move
rule_number to rule_number
no ip telnet server rule rule_number
show ip telnet server status

33.6.1 Telnet Commands Examples

This command sets a service control rule that allowed the computers with the IP addresses
matching the specified address object to access the specified zone using Telnet service.
Router# configure terminal
Router(config)# ip telnet server rule 11 access-group RD zone LAN action
-> accept
This command displays Telnet settings.
Router# configure terminal
Router(config)# show ip telnet server status
active
port
service control:
No. Zone
========================================================================
Router(config)#
212
DESCRIPTION
Allows Telnet access to the UAG CLI. The
to the UAG CLI.
service port number back to the factory default (23).
Sets a service control rule for Telnet service.
address_object: The name of the IP address (group) object. You may use 1-
31 alphanumeric characters, underscores(
character cannot be a number. This value is case-sensitive.
zone_object: The name of the zone. Use up to 31 characters (a-zA-Z0-9_-).
The name cannot start with a number. This value is case-sensitive.
The UAG uses pre-defined zone names like DMZ, LAN1, LAN2, SSL VPN, IPSec
VPN, and WAN.
Changes the index number of a service control rule.
Deletes a service control rule for Telnet service.
Displays Telnet settings.
: yes
: 23
Address
configure
command disables Telnet access
no
command resets the Telnet
no
), or dashes (-), but the first
_
Action
UAG CLI Reference Guide