ZyXEL Communications UAG Series Cli Reference Manual page 126

Chapter 18 Firewall
The following table describes the session-limit commands. You must use the
command to enter the configuration mode before you can use these commands.
terminal
Table 66 Command Summary: Session Limit
COMMAND
[no] session-limit activate
session-limit limit <0..8192>
session-limit rule_number
[no] activate
[no] address address_object
[no] description description
exit
[no] limit <0..8192>
[no] user user_name
session-limit append
session-limit delete rule_number
session-limit flush
session-limit insert rule_number
session-limit move rule_number to
rule_number
show session-limit
show session-limit begin rule_number end
rule_number
show session-limit rule_number
show session-limit status
126
DESCRIPTION
Turns the session-limit feature on or off.
Sets the default number of concurrent NAT/firewall sessions per host.
Enters the session-limit sub-command mode to set a session-limit rule.
Enables the session-limit rule. The
limit rule.
Sets the source IP address. The
means all IP addresses.
Sets a descriptive name (up to 64 printable ASCII characters) for a
session-limit rule. The command removes the descriptive name
no
from the rule.
Quits the sub-command mode.
Sets the limit for the number of concurrent NAT/firewall sessions this
rule's users or addresses can have. 0 means any.
Sets a session-limit rule for the specified user. The
the user name to the default (
Enters the session-limit sub-command mode to add a session-limit rule
to the end of the session-limit rule list.
Removes a session-limit rule.
Removes all session-limit rules.
Enters the session-limit sub-command mode to add a session-limit rule
before the specified rule number.
Moves a session-limit to the number that you specified.
Shows the session-limit configuration.
Shows the settings for a range of session-limit rules.
Shows the session-limit rule's settings.
Shows the general session-limit settings.
configure
command disables the session
no
command sets this to
no
command resets
no
). means all users.
any any
UAG CLI Reference Guide
, which
any