Roland MV-8800 Appendices page 62

Effect Block
Dly/Cho (Delay/Chorus) effect
Chorus
Rate
Range: 0.05–10.00 Hz
When Sync parameter is Off, this sets the pitch vibrato
speed.
Sync
Value: Off, On
Set this parameter to On when synchronizing the
modulation time to the song tempo. When not
synchronizing, turn this off.
Note
Range: , , ,
, , ,
When Sync parameter is On, you select the note, the
modulation time is set to match the length of the note.
Depth
Value: 0–127
Sets the pitch vibrato depth.
Feedback
Value: 0–127
Adjusts the amount of the chorus sound that is fed back
into the effect.
Phase
Value: 0–180 deg
Sets the spatial spread of the sound.
Pre Delay
Value: 0.0–100.0 ms
Adjusts the delay time from the direct sound until the
chorus sound is heard.
Filter Type
Sets the filter type.
Value Explanation
Off no filter is used
LPF cuts the frequency range above the Cutoff Freq
HPF cuts the frequency range below the Cutoff Freq
Cutoff Freq
Value: 200–8000 Hz
Sets the basic frequency of the filter
A-62
MV-8800 Appendices
, , , , , , , , ,
, , , , ,
Delay
Time
Value: 0–1000 ms
When Sync parameter is Off, adjusts the delay time from
the direct sound until the delay sound is heard.
Sync
Value: Off, On
Set this parameter to On when synchronizing the delay
time to the song tempo. When not synchronizing, turn
this off.
,
Note
Range: ,
,
When Sync parameter is On, you select the note, the
delay time is set to match the length of the note.
Level
Value: 0–127
Sets the volume of the delay sound.
Left/Center/Right
Sets the parameter of the delay sound of left, center and
right channel.
Feedback
Value: -98–98%
Adjusts the proportion of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
HF Damp
Value: 200–8000 Hz, Bypass
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies, set this parameter to Bypass.
, , , , , , , , ,
, , , , , , ,
, , ,