Roland MV-8800 Appendices page 45

Feedback Level
Value: 0–100
Sets the repeat times for the delay sound. When set to 0,
each delayed sound is played only once. (if the Mode is
"Alternate" (Alt), delayed sound in each channel are
played only once.)
• Increasing the value too highly may cause oscillation
in the sound.
Effect Level
Value: 0–100
Sets the volume of the delay sound. Adjust this after
getting a balance with the direct level.
Direct Level
Value: 0–100
Sets the volume of the source sound. It is ordinarily set
to 100
• The effect is abbreviated as "Delay" in the screen. Although
the algorithm is similar to that of "06 EZ Delay", functions
are simplified, for example with the omission of High and
Low Damp. Long delays of up to a maximum of 2.4
seconds are available in Monaural mode.
ChoFln (Chorus/Flanger)
This provides you with chorus or flanger effects to suit your
needs. Chorus is an effect that adds breadth and fullness to
the sound. The flanger gives you effect that is like a jet sound
rising and falling.
Mode
Value: Chorus, Flanger
This selects either the chorus or the flanger.
Rate
Value: 0–100
This sets the chorus or flanger modulation cycle time.
This has no effect and cannot be set when Tempo Sync
is in use.
Depth
Value: 0–100
This sets the chorus or flanger modulation depth.
Manual
Value: 0–100
When the effect mode is set to Flanger, this control sets
the center frequency to which the effect is applied. The
pitch of the flanger effect's metallic sound is changed.
This is disabled when set to Chorus mode.
Resonance
Value: 0–100
This sets the amount of reinforcement of the flanger
effect. This setting is disabled when set to Chorus mode.
Effect Block
A-45
MV-8800 Appendices