Roland MV-8800 Appendices page 20

Effect Block
03 St. Dynamics Processor
Comp (Comp/Limiter)
This effect is able to use as a compressor, which controls
inconsistencies in sound levels by suppressing high sound
levels while lifting weaker signals, or as a limiter that prevents
the signal from reaching exceedingly high levels.
Threshold
Value: -60–0 dB
Sets the volume level at which the compression begins.
Ratio
Value: 1:1.5, 1:2, 1:4, 1:100
Sets the "source sound:output sound" compression ratio.
Attack
Value: 0–100
Sets the time after the sound volume is crossed the
threshold level until compression begins.
Release
Value: 0–100
Sets the time for compression to stop after the sound
falls back under the threshold level.
Output Level
Value:-60–12 dB
Sets the output volume.
• When used as a limiter, set the Ratio to 100:1 with a short
release time. If the volume exceeds the threshold level, the
sound is suppressed instantly detected as the excess
input.
A-20
MV-8800 Appendices
Enhan (Enhancer)
This effect regulates the high-end overtones, clarifying the
sound and the sound contour.
Sens
Value: 0–100
Sets the degree to which the Enhancer is applied.
Freq
Value: 1.0–10.0 kHz
Sets the lower limit of the frequencies to which the
enhancement effect is added.
Mix Level
Value: 0–100
Sets the level of the overtones produced by the
Enhancer that is mixed in with the source sound.
Output Level
Value: 0–100
Sets the output volume.