Bunn VLPF Operating & Service Manual page 6

ADJUSTING BREW VOLUMES(cont)
2. Setting batch sizes. To set a batch volume, first check that the SET/LOCK switch is in the "SET" position on
the circuit board. Press and hold the START or BREW switch until three distinct clicks are heard, and then
release the switch. (Failure to release the switch within two seconds after the third click causes the volume
setting to be aborted and previous volume setting will remain in memory). View the level of the liquid being
dispensed. When the desired level is reached, turn the ON/OFF switch to "OFF". The brewer remembers this
volume and will continue to brew batches of this size until the volume setting procedure is repeated.
NOTE: When brewing coffee, batch volumes will decrease due to absorption by the coffee grounds.
3. Setting programming disable feature. If it becomes necessary to prevent anyone from changing brew times
once programmed, you can set the SET/LOCK switch to the "LOCK" position. This will prevent any program-
ming to be done until switch is once again placed in the "SET" position.
1. Insert a BUNN filter into the funnel.
®
2. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.
3. Slide the funnel into the funnel rails.
4. Place the On/Left switch in the upper position.
5. Press the Start switch.
6. When brewing is completed, simply discard the grounds and filter.
NOTE - Any attempt to draw hot water from the faucet during a brew cycle will result in a lesser amount of fin-
ished beverage in the decanter.
1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
2. Check and clean the sprayhead. The sprayhead holes must always remain open.
3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube. When
inserted properly , no more than two inches of spring should be visible. Saw back and forth five or six times.
Then, repeat this step for the airvent tube.
NOTE - In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer
and takes less than a minute.
COFFEE BREWING
CLEANING
Page 6
10179 060100