Advertisement
VP17
Series
Supercedes Operating Manuals:
10860.####
INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601
FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, Illustrated Parts Catalog, Pro-
gramming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com.
This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates.
For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
46720.0000D 09/17 ©2013 Bunn-O-Matic Corporation
Advertisement
Table of Contents
Related Manuals for Bunn VP17-3T
Summary of Contents for Bunn VP17-3T
- Page 1 To ensure you have the latest revision of the Operating Manual, Illustrated Parts Catalog, Pro- gramming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates.
-
Page 2: Warranty
AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages. -
Page 3: Table Of Contents
DAMAGE, FIRE, OR SHOCK HAZARD READ THE ENTIRE OPERATING MANUAL BEFORE BUYING OR USING THIS PRODUCT THIS APPLIANCE IS HEATED WHENEVER CONNECTED TO A POWER SOURCE 00831.0000M 11/14 ©1998 BUNN-O-MATIC CORPORATION # 00658.0000 # 00831.0000 WARNING CAUTION WARMERS AND SURFACES ARE HOT... -
Page 4: Ce & North American Requirements
CE REQUIREMENTS • This appliance must be installed in locations where it can be overseen by trained personnel. • For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C. • Appliance shall not be tilted more than 10° for safe operation. •... -
Page 5: Electrical Requirements
ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up. The 120V brewer has an attached cordset and requires 2-wire grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz. "A"... -
Page 6: Initial Setup, Coffee Brewing & Cleaning
8. Empty the decanter. The brewer is now ready for use in accordance with the coffee brewing instructions. NOTE: The control thermostat will need to be adjusted downward to compensate for high altitudes. Refer to chart. COFFEE BREWING 1. Insert a BUNN filter into the funnel. ®... -
Page 7: Troubleshooting
TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department. • Inspection, testing, and repair of electrical equipment should be performed only by qualified service person- nel. - Page 8 TROUBLESHOOTING (cont.) PROBABLE CAUSE PROBLEM REMEDY Refer to Service - Tank Heater for Water is not hot (cont.) 4. Tank Heater testing procedures. The brewer must be level or Inconsistent beverage level in 1. Syphon System dispenser slightly lower in front to syphon properly.
- Page 9 3. Sprayhead A six-hole stainless steel spray- head must be used for proper extraction. 4. Funnel Loading The BUNN paper filter must be ® centered in the funnel and the bed of ground leveled by gentle shaking.
Need help?
Do you have a question about the VP17-3T and is the answer not in the manual?
Questions and answers