ResMed H4i Water Chamber Upgrade Kit Quick Start Manual

Hide thumbs Also See for H4i Water Chamber Upgrade Kit:

H4i Water Chamber Upgrade Kit

Thank you for choosing the H4i Water Chamber Upgrade Kit.

This product allows the H4i water chamber to be used with the HumidAire 3i heated humidifier.

WARNING

Take care when handling your humidifier. The water and the water chamber base may both be hot.

Allow 10 minutes for the heater plate and any excess water to cool.

Fitting your H4i Water Chamber

To start using your new H4i water chamber, attach the provided cover and cover seal to your

HumidAire 3i docking station using the following steps:

Remove the HumidAire 3i cover and cover seal by

gently flexing one cover arm away and up from the

docking station until the cover detaches completely.

Note: The HumidAire 3i cover and cover seal cannot

be used with the H4i water chamber.

To attach the H4i cover, put one cover arm into its

pivot point on the docking station and gently flex

the other arm into its corresponding point. The

cover should be able to open and close freely while

securely attached to the docking station.

Ensure that the cover seal provided

is properly attached to the H4i cover

by aligning the cover seal to the

guides on the cover and pressing

along the edges.

Place the H4i water chamber in the

HumidAire 3i docking station and

close the top cover ready for use.

Table of Contents

Do you have a question about the H4i Water Chamber Upgrade Kit and is the answer not in the manual?

Page 1 H4i Water Chamber Upgrade Kit Thank you for choosing the H4i Water Chamber Upgrade Kit. This product allows the H4i water chamber to be used with the HumidAire 3i heated humidifier. WARNING Take care when handling your humidifier. The water and the water chamber base may both be hot.
Page 2 Let the solution soak for 10 minutes. Discard the solution and rinse the water chamber with clean water. ©2008 ResMed Ltd. 268255/1 08 08 Global leaders in sleep and respiratory medicine...