Roland VS-1824 User Manual page 114

Add Finishing Touches to Your Song
After Rec (after recording)
Specify the time location of the mastering track to which the mixdown will
be recorded. When creating an original audio CD, it is usually best to select
"to ZERO."
to ZERO:
to last Phrs:0S:
to last Phrs:2S:
to last Phrs:4S:
Stay HERE:
fig.2-05.e
to ZERO
0 Time
to LastPhrs:0s
0 Time
CDRRecMode (CD-R recording mode)
This is the switch for setting whether to record the mastering tracks in CDR
mode.
Off: The mastering tracks are recorded using the recording mode of the
present song.
On: The mastering tracks are recorded in CDR mode. This allows you to
skip the step of creating an image file when writing to the CD, so it
can shorten the write time.
FXIns (effects insert)
Determines which effects are to be inserted in the mastering tracks.
None inserted.
Off:
1234: Press [ENTER], and select the effects you want to insert. Numbers
corresponding to the effects you use are displayed.
fig.5-24a
114
Place the data starting at 00h00m00s00f
Place the data after the end of the last phrase in the
mastering tracks.
Place the data two seconds after the end of the last
phrase in the mastering tracks.
Place the data four seconds after the end of the last
phrase in the mastering tracks.
Place the data at the time location at which it was
actually recorded.
Mixdown
Phrase
Original
Phrase
0 Time
to LastPhrs:0s
0 Time 0
Stay HERE
0 Time
to LastPhrs:2s
Time
Depending on the After
Rec (After Recording)
setting or on the location
relative to other markers,
the display may indicate
"Can't Set Marker," and the
track number marker may
not be assigned.