SMC Networks SMC9432BTX User Manual page 54

T
ROUBLESHOOTING
K
Make sure the PCI slot is configured to support INTA.
K
Be sure that INTA for the slot is assigned to a free interrupt
(IRQ) number.
K
Check the BIOS setup program's PCI parameters for the slot
where the EtherPower II 10/100 network card is installed. Be
sure the slot is configured for level-triggered interrupts instead
of edge-triggered interrupts. An example of typical PCI
parameters follows:
PCI Slot #:
Master:
Slave:
Latency Timer:
Interrupt Type:
Interrupt Number:
Note that the wording of these parameters varies with different
computers, and not all parameters may be configurable.
Always consult your computer manual for information on changing
motherboard jumper settings and BIOS Setup program parameters
for use with PCI network cards. If you set a motherboard jumper
and modify the computer's BIOS Setup, make sure the jumper and
BIOS settings match.
A-2
(slot number where the network
card is installed)
Enabled
Enabled
40 (range is 20 to 255)
Level-Triggered
(choose any number the BIOS
Setup supplies that does not
conflict with another
installed card)