Troubleshooting; Pci Compatibility - SMC Networks SMC9432BTX User Manual

PCI Compatibility

Early PCI BIOS versions do not properly support the PCI
specification and may "hang" when a network card driver tries to
load. If this occurs, make sure your BIOS correctly supports the PCI
Local Bus Specification (v2.0 or later) and upgrade your computer
BIOS to the latest version.
Some PCI computers are not self-configuring and require you to
perform some or all of the following functions by changing
motherboard jumpers and/or configuring the BIOS setup program:
K
Verify that the PCI slot is an enabled busmaster slot and not a
slave PCI slot. The EtherPower II 10/100 card must be installed
in a PCI busmaster slot. In some computers the PCI slot must
be configured to enable bus mastering. Refer to your PC's
manual and check the PCI BIOS setup program to be sure the
PCI slot is an enabled busmaster slot.
K
In some computers, you may be required to disable Plug 'n
Play (PnP) in the BIOS setup program if resources are not
properly assigned between the network card and other
installed cards.
K
Some computers may require you to reserve interrupts and
memory addresses for installed ISA cards to prevent PCI cards
from using the same settings. Refer to your PC's manual and
check the PCI BIOS setup program configuration options for
ISA cards.
A
PPENDIX
T
ROUBLESHOOTING
A
A-1