Receiver Installation; Installation Instructions - Hunter Universal Fan and Light Remote Control Owner's Manual And Installation Manual

1. USE THE PULL CHAIN SWITCH TO SET THE FAN SPEED TO THE HIGH POSITION BEFORE
INSTALLATION. DO NOT USE THE PULL CHAIN TO CHANGE THE FAN SPEED AFTER
INSTALLATION, AS DAMAGE TO YOUR CEILING FAN OR UNIVERSAL CONTROL MAY RESULT.
THE SPEED OF THE FAN SHOULD ONLY BE CHANGED BY THE HUNTER CONTROL!!
2. Set the ceiling fan light kit to the ON position before installation.

Installation Instructions:

1. Install the ceiling fan according to its instructions, up to the point of making the electrical connections. Connect receiver to
ceiling fan according to the mounting types shown on the next page. Determine your ceiling fan mounting type from the
images on Pages 4-5. Most installations will be one of these five types.
2. If the fan is already installed, turn the power OFF at the main electrical panel. Reverse the installation procedure according
to the fan instructions, to the point of disconnecting the fan wiring. Connect the receiver to the ceiling fan according to the
mounting type as shown on Pages 4-5.
IMPORTANT! If your ceiling fan light kit is using incandescent bulbs, then slide the CFL / INC switch to the INC position.
(Fig. 2) If your ceiling fan light kit is using compact fluorescent light bulbs (CFL), then slide the CFL / INC switch to the CFL
position. NOTE: When the switch is in the CFL position, the dimming feature is disabled, and you will not be able to dim the
light bulbs. This feature is to protect both your bulbs and your receiver as CFL bulbs are not able to dim and will malfunction if
dimming is attempted.
Low Profile Style I (Figure 1): Secure receiver to the fan plate above the motor with UL-listed cable ties (not included).
Connect wiring as shown in Figure 6. Extend antenna through one of the ceiling plate
openings (approximately 3–6˝).
NOTE: Some fans may have considerable excess lead wire. For easier canopy
installation, cut the excess wire leaving a minimum of 6 inches remaining. Restrip
the fan lead wires 1/2 inch. Place remaining excess wire into the ceiling electrical box
as needed.
3 • Receiver Installation
BEFORE INSTALLING THE CONTROL:
44092-01 • 12/15/10 • Hunter Fan Company
4
Figure 1
INC CFL
Cable Tie Routing for Low Profile
Fans (Figs.1 & 3): Insert cable tie through
openings as shown. DO NOT insert the cable
tie through the inside of the receiver. The
cable tie can be placed across the length or
width of the receiver to best match your fan
installation type.
Low
Profile
Style 1
CFL Toggle
Switch
Figure 2