Access-List Standard - TP-Link TL-SL2210 Reference Manual

TL-SL2428(config)# mac access-list 23

access-list standard

Description
The access-list standard command is used to add Standard-IP ACL rule. To
delete the corresponding rule, please use no access-list standard command.
Standard-IP ACLs analyze and process data packets based on a series of
match conditions, which can be the source IP addresses and destination IP
addresses carried in the packets.
Syntax
access-list standard acl-id rule rule-id { deny | permit } [[ sip source-ip ] smask
source-ip-mask] [[ dip destination-ip ] dmask destination-ip-mask ]
no access-list standard acl-id rule rule-id
Parameter
acl-id —— The desired Standard-IP ACL for configuration.
rule-id —— The rule ID.
deny —— The operation to discard packets.
permit ——The operation to forward packets. It is the default value.
source-ip —— The source IP address contained in the rule.
source-ip-mask —— The source IP address mask. It is required if you typed
the source IP address.
destination-ip —— The destination IP address contained in the rule.
destination-ip-mask —— The destination IP address mask. It is required if you
typed the destination IP address.
Command Mode
Global Configuration Mode
Example
Create a Standard-IP ACL whose ID is 120, and add Rule 10 for it. In the rule,
the source IP address is 192.168.0.100, the source IP address mask is
255.255.255.0, and the packets match this rule will be forwarded by the switch:
TL-SL2428(config)# access-list create 120
TL-SL2428(config)#
192.168.0.100 smask 255.255.255.0
access-list standard
103
120 rule 10 permit sip