Optical Drive Problems - Lenovo 3057 Maintenance Manual

Symptom
The ThinkServer EasyStartup DVD does not start.
The operating system installation program continuously
loops.
The ThinkServer EasyStartup program cannot start the
operating system medium.

Optical drive problems

Follow the suggested actions for the corresponding symptom in the order in which they are listed until the
problem is solved. If none of these actions solve the problem, see "Troubleshooting procedure" on page 191
for the subsequent steps you should check after using the information in this topic. If the problem still cannot
be solved, seek technical assistance. See Chapter 8 "Getting information, help, and service" on page 197.
Notes:
• If you are instructed to remove, install, or replace any CRUs, refer to the related procedure in Chapter 6
"Installing, removing, or replacing hardware" on page 83.
• If an action step is preceded by "(Trained service technician only)," this action step is reserved for a trained
service technician and must be performed only by a trained service technician.
Symptom
The internal optical drive is not recognized.
Action
1. Ensure that the server supports the ThinkServer
EasyStartup program and has a bootable DVD drive
installed or a bootable external DVD drive attached.
2. Ensure that you have set the optical drive with the
ThinkServer EasyStartup DVD installed as the first
startup device. See "Selecting a startup device" on
page 66.
3. Verify if the optical drive or the disc has problems.
See "Optical drive problems" on page 193.
Make more space available on the hard disk drive.
1. Ensure that the operating system medium is
supported by the ThinkServer EasyStartup program
version your are using. For a list of the supported
operating systems, refer to the user guide and
compatibility notes for the ThinkServer EasyStartup
program through the program main interface. See
"Starting the ThinkServer EasyStartup program" on
page 70.
2. Verify if the optical drive or the disc has problems.
See "Optical drive problems" on page 193.
Action
1. Ensure that:
• The related cables and connectors are not
damaged and the connector pins are not bent.
• The optical drive is securely connected to the
correct SATA connector on the system board and
the SATA connector is enabled in the Setup Utility
program. See "Using the Setup Utility program"
on page 61.
• All cables and jumpers (if any) are installed
correctly.
• The correct device driver is installed for the optical
drive.
2. Run any optical drive diagnostic programs if you
have.
3. Reinstall the optical drive and reconnect cables.
.
Chapter 7 Troubleshooting and diagnostics
193