Lenovo 3057 Maintenance Manual page 105

a. On each side of the server, insert the signal cable of the rack handle into the hole
and then push the signal cable through the hole into the chassis. When the signal cable is protruding
from the crack between the side edge of the backplane and the inner side of the chassis, hold the
signal cable from the rear and carefully pull it into the chassis until it is stopped by the rack handle.
b. Insert the two small tabs on the rack handle into the corresponding holes
that the screw hole in the rack handle is aligned with the corresponding hole
install the screw to secure the rack handle on each side of the server.
Figure 49. Installing the rack handles
.
Chapter 6 Installing, removing, or replacing hardware
1 in the chassis
2 in the chassis. Ensure
3 in the chassis. Then,
91