Removal Of Covers For Servicing; Removal Of Components For Service; Parts Replacement; Adjustments And Replacement Parts - Heat & Glo SL-550TRSI-AUE Installation And Operation Instructions Manual

3.1 REMOVAL OF COVERS FOR
SERVICING
A. Control Compartment Door
• Rotate the lower door down to access the gas controls.
B. Dress Guard and Glass Door
• Lift the front dress guard up and out away from the
appliance side surrounds. Replace the dress guard
when servicing is complete.
• Release the four glass clips around the glass door.
Carefully lift the glass up and out away from the ap-
pliance (see Figure 39).
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
Figure 39. Glass Assembly
3.2 REMOVAL OF COMPONENTS
FOR SERVICE
1. BURNER
• Carefully remove the log set. Remove the rear screws
holding the log grate. Remove log grate and metal
base pan.
• Unscrew the brackets at both ends of the burner and
the retaining screws at the pilot bracket (see Figure
40). Slide the burner towards the right away from the
burner orifice.
Figure 40.
CAUTION: ALL SCREWS WHICH WERE
REMOVED MUST BE REPLACED.
PILOT BRACKET
RETAINING SCREWS
Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06
2. PILOT ASSEMBLY/IGNITION SYSTEM
• Remove the log set, log grate, metal base pan and
burner.
• Disconnect the gas supply tube from the back of
the gas valve and the thermocouple from the
interruptor block.
• Disconnect and remove the pilot assembly from the
bracket.
NOTE: When removing the pilot assembly, carefully
pull the electrode wire up through the grommeted hole
in the base pan.
3.3

PARTS REPLACEMENT

1. FAN/SWITCHES
• Disconnect the fan wires from the junction box wires
by pulling the male and female connectors apart and
slide the fan out the front of the lower controls com-
partment.
• Disconnect the wires from the fan speed control
switch, pull off the knob, and remove the nut holding
the speed control to the bracket.
• Disconnect the wires from the fan temperature sen-
sor switch and remove the nut holding the switch
bracket onto the side of the firebox.
2. GLASS PANEL
• To replace the glass door, place the bottom edge on
top of the bottom mounting brackets. Push glass
against unit and latch the two fasteners at the top of
the glass door and the two fasteners at the bottom
(see Figure 39).
3.4 ADJUSTMENTS AND
REPLACEMENT PARTS
Adjustments and replacement parts for this appliance
should only be done by a qualified service person. A
wiring diagram for the appliance is shown in SECTION
2.0 OPERATING INSTRUCTIONS. A replacement part
table is shown in SECTION 4.0 of this manual.
33