Operating Controls & Coffee Brewing - Bunn Axiom BrewWISE Series Installation & Operating Manual

P3633
A
D
COFFEE BREWING
1. Begin each brew cycle with a clean empty brew funnel.
2. Insert a BUNN filter into the funnel.
3. Pour (or grind) fresh coffee into the filter and level the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" indicator is on.
7. Momentarily press and release the "BREW" switch. The display will read "NOW BREWING", and
show the time remaining in the brew cycle.
8. Following the brew, the display reads "DRIPPING" which shows the time remaining until the cof-
fee no longer drips from the funnel tip.
9. After the coffee finishes dripping from the funnel tip, carefully remove the brew funnel and discard
the grounds and filter.
OPERATING CONTROLS
(A) ENABLE BREW ON/OFF SWITCH
Pressing the "ENABLE BREW ON/OFF" switch (indicator on)
supplies power to the brew station warmer and enables the
brew circuit. Pressing the switch again (indicator off) stops
brewing and de-energizes the brew station warmer. Stopping
a brew cycle after it has been started will not stop the flow
of water into the server until the funnel is empty.
(B) BREW SWITCH
B C
brew cycle when the "ENABLE BREW ON/OFF" indicator
is on.
(C) ADDITIONAL WARMER SWITCHES
Pressing any additional warmer switch so that the indicator is on,
supplies power to the associated warmer. NOTE: APS & TC models
have no warmers.
(D) MAIN ON/OFF SWITCH
This switch, located on the left side of the brewer, turns power on and off
to all components in the brewer.
P3969.50
Momentarily pressing and releasing the switch starts a
Page 7
39130.4 040212