Bunn Axiom BrewWISE Series Installation & Operating Manual page 18

ADJUSTMENTS & OPTIONAL SETTINGS (CONT.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
NOTE: Access to the remaining functions in LEVEL 2 is intended for trained service personnel only.
More in depth information can be found in the Axiom Service Manual 39132.0000
SET PASSWORD
0 0
SET LANGUAGE
NO
UNITS
METRIC DONE
SET TEMP:
(-) DONE
SET READY:
(-) DONE
ENTER ASSET # ?
NO
SET PULSE BREW ?
NO
Any 3 digit number may be programmed to prevent unauthor-
ized access of LEVEL 2. BE CAREFUL TO USE A CODE YOU WILL
0
REMEMBER!
Choose between English or Spanish. After selecting "YES",
press either ( + ) or ( - ) to select, then choose "YES" again
YES
when asked, "ARE YOU SURE?"
Choose between English or Metric units. Display will read:
"CHANGING UNITS WILL CAUSE" "ALL SETUP INFO TO BE
ENG
LOST" "ARE YOU SURE?" "NO
is set for Metric Units, displays will be different. (ex: Brew oz
will become Brew milliliters, ° F will be ° C).
Adjusts brew tank temperature.
200°
RANGE: (185 to 205° F) or (85 to 96° C)
(+)
This function sets the minimum temperature allowable to start
195°
a brew cycle. Range: (2° to 20° F) or (2° to 10° C) below the set
(+)
temperature. The water must be at the "READY" temperature
or higher for the display to indicate "READY TO BREW".
This function allows the you to enter in an optional asset num-
ber. This can be useful for tracking the usage or service of an
YES
individual machine within a group.
This function allows the sprayhead to "pulse" on and off dur-
ing a brew cycle. These times can be set two different ways.
YES
The first is by setting the total brew time in the "EASY PULSE
BREW" screen. The other option allows the actual times to be
entered in the "MANUAL PULSE BREW" screen.
NOTE: This will overwrite settings in "BREW METER".
Page 18
YES". NOTE: If the brewer
39130.4 040212