Brew Wizard Program Functions - Bunn Axiom BrewWISE Series Installation & Operating Manual

The programming of the brewer is divided into two levels. Brewing adjustments are in "BrewWiz-
ard". Service functions are accessed in Level 2.
The following function screens are in order of appearance. Each screen will have instructions on
how to access, and the procedures to program the various functions of the brewer.
To exit the programming mode at any time, press and release "ENABLE BREW ON/OFF" switch
located on the front switch panel. The display will return to the MAIN SCREEN.
If none of the five programming switches are pressed within one minute during the setup of the
brewer, the programming of the function screen that is being set will be exited and the display will
return to the MAIN SCREEN.
Always remember to place an empty server and funnel under the sprayhead when operating the
brewer during the set-up of PULSE BREW, CALIBRATE FLOW and testing the brew valve in SER-
VICE TOOLS/TEST OUTPUTS.
MAIN SCREEN
READY TO BREW
WATER TEMP: 200°
PROGRAMMING LOCKOUT SWITCH
MAIN SCREEN
(Mounted on main control board)
The main screen will alternate between "READY
This switch can be set to prevent access to the
TO BREW"/"WATER TEMP" and TIME/DATE/
programming settings of the brewer. Once all the
YEAR. Will also indicate if the glass or thermal
correct brew settings are programmed, the operator
carafes are ready to brew into (green lights) or
can set the switch to the "LOCK" position to prohibit
almost expired (yellow lights) or expired (red
anyone from changing the settings. With the switch
lights)
in the "LOCK" position, the programming menus
can still be accessed to view the current settings.
However, no changes will be saved.
LO CK
SE T
ADJUSTMENTS & OPTIONAL SETTINGS
PROGRAMMING THE BREWER
IMPORTANT PROGRAMMING NOTES
- READ CAREFULLY -
PROGRAM FUNCTIONS - BREW WIZARD
Disconnect brewer from
power source before
removing any panel!
This function allows the operator to prevent
or allow brewing if the water temperature is less
than the set READY temperature.
To access this function screen press and hold
the right hidden switch. Release when the display
reads: "BREW WIZARD" it will then read:
BREW LOCKOUT?
NO
Press here
for NO
The YES or NO should be flashing. Select YES
to prevent brewing if the water temperature is
below the set READY temperature. Select NO
to permit brewing at any water temperature.
When finished, press and release DONE. This
will step to the next function screen. To return
to the MAIN SCREEN at any time, press and
release "ENABLE BREW ON/OFF".
Page 12
BREW LOCKOUT
DONE YES
Press here Press here
for DONE for YES
39130.4 040212