Table of Contents
Advertisement
Configuration Guide <memory / ODD / FDD>
Memory [std. 1 / max.4]
UP to four memory modules can be installed.
You can expand the memory capacity up to 16GB(4x 4GB) by replacing the standard DIMM.
Additional memory module (1x 1GB)
Additional memory module (1x 2GB)
Additional memory module (1x 4GB)
NOTE
1x 1GB DIMM is factory-installed.
The memory module available for the GT110b are DDR3-1333(PC3-10600) Unbuffered type with ECC
(but memory of Celeron G1101 model, Pentium G6950 model frequency is 1066MHz)
Memory extension by one DIMM is possible, but a set of two DIMMs (same capacity) is recommended. (for
2way interleave)
If there are different capacity DIMMs, larger capacity DIMMs should be installed in the smaller number slots.
For more details about the memory size supported by each OS, please refer to the "Supplementary Notes
<Memory (1)>" at the end of this document.
Optical disk drive (installed 5inch device bay)
Optical disk drive
ÿ
max.1 , not possible to use both two drives in a system)
DVD-ROM drive
Flash FDD (connect to USB port)
Flash FDD
1.44MB
Notes
FDD is NOT included as standard. Arrange Flash FDD if needed. For intended uses, refer to the Flash
FDD Supplementary Notes in this guide.
Only one Flash FDD can be connected in the system.
Six port USB (rear x2, front x4) interface as standard.
(USB)
[N8102-342F]
[N8102-343F]
[N8102-344F]
standard
[N8160-86]
2003
2003R2
R2x64
EL4
EL4x64
EL5
Express5800/GT110b
2008
2008x64
2008 R2
S L 1 0
S L 1 0 ÿ X 6 4
EL5x64
6
Advertisement
Table of Contents
