Figure; Setup; Setting Up The Motion Control Levers - Hayter RZT420H Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note: Determine the left and right sides of the machine from the normal operating position.
1

Setting Up the Motion Control Levers

No Parts Required
Procedure
1. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch) as shown in Figure 3.
Raise the motion control levers.
2. Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer
removed previously (Figure 3). Hand tighten all fasteners. Repeat this for both controls levers.
Description
No parts required
Clevis pin
Hair Pin
No parts required
Ignition Key
Operator's Manual
Engine Operator's Manual
Qty.
–
Set up the motion control levers.
1
Install the seat cable.
1
–
Connect the battery.
1
1 Complete the Setup.
1

Figure 3

10
Use