Olivetti d-Color MF25 User Manual page 105

Before making copies
!
Detail
The default settings are those that are selected immediately after the ma-
chine is turned on (the power switch is set to "n") and before any setting
is specified from the control panel or touch panel, and those that are se-
lected when the [Reset] key is pressed to cancel all settings specified
from the control panel or touch panel. The default settings can be
changed. For more details, refer to "Initial setting" on page 12-28.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
Note
A job can also be queued while the machine is warming up after the
[Power] (auxiliary power) key is pressed. For details, refer to "To scan dur-
ing warm-up" on page 2-28.
After the machine has finished warming up, the scanned image will be
printed.
The machine takes about 110 seconds to warm up at normal room tem-
perature (23°C) when the control panel is turned on using the [Power]
(auxiliary power) key after the machine is turned on using the main power
switch.
d-Color MF25
2
2-27