Kenmore Use & Care Guide Use & Care Manual page 28

3. Put the new orifice into the orifice
removal tool (B), and then insert the tool
into the burner opening and tighten the new
orifice to the valve.
Make sure you are using the correct orifice,
which is marked "1.44". (Fig. 7)
4. Replace burner and screws. Make sure
to engage the tube over valve as shown. (Fig. 8)
Side Burner Conversion
1. Remove the side burner screws
(5/32-32x3/8 in.) to expose the side burner
valve. Insert the tool onto the valve and
unscrew orifice from end of valve. Put the
new orifice into the orifice removal tool and
tighten the new orifice into the valve.
Make sure you are using the correct
orifice, which is marked "1.31". (Fig. 9)
2. Engage burner tube over valve as shown. (Fig. 10)
The sear burner
The side burner
28
1.44
Fig. 7
5/32-32x3/8 in. screw
Fig. 10
B
Fig. 8
Fig. 9