Stopping; Height Of Cut; Before Mowing - Hayter Harrier 41 Electric Owner's Handbook Manual

OPERATING THE MOWER

Stopping

Height of Cut

Before Mowing

1.12
Release the motor switch control lever to stop the motor.
WARNING: AVOID ACCIDENTS - The cutterblade may contin-
ue to rotate after the mower is switched off
Hold the trigger against the handle and raise or lower the mower using
the handle to achieve the desired height of cut. Release the trigger to
secure the mower at the required position.
There are seven height of cut positions. The setting is indicated by the
position of the connecting rod relative to the height of cut indicator.
Always select a height of cut to suit operating conditions. Aim to pre-
vent motor overloading and blockages by avoiding low cuts in long
grass conditions. Be prepared to make two cuts when the grass is long.
To prevent accidents thoroughly inspect the area and remove all
objects which when contacted by the mower cutterblade could
become dangerous projectiles. Inspect the area for hidden obstruc-
tions which when contacted by the cutterblade could risk health
and safety. Remember the location of these obstructions and
ensure that you mow around them.