Assembling The Mower; Delivery Checklist; Handlebar; Adjust Handlebar Height - Hayter Double 3 533A Owner's Handbook Manual

ASSEMBLING THE MOWER

Delivery Checklist

Handlebar

Adjust Handlebar Height

Grassbag Attachment

1.9
Remove the mower from the packaging and check that the following
items have been supplied correctly. If any items are missing contact,
your local Hayter dealer.
1. Engine Handbook.
2. Warranty Reg. Card.
3. Grassbag.
To prevent accidents cut off the long ribbon attached to the grass-
bag and discard.
Unscrew the handlebar securing knobs sufficiently to allow the handle-
bar to pivot. Unfold the handlebar to the operating position. Tighten both
handlebar knobs to secure the handlebar in position.
Take care to ensure that the control cables do not become snagged at
the pivot point.
Remove the 'R' Clip. Locate the pin in one of the three holes in the
adjuster strap for best position and comfort. Ensure both sides are set
to the same height. Secure in the required position with the 'R' Clips.
The mower is shipped with a 'Mulcher Plug' fitted inside the dis-
charge chute. Open the rear door and remove prior to initial use.
To attach the grassbag, Open the rear door and lower the grassbag
through the handlebar making sure the top corners of the grasbag
frame hook over the rear plate and into position.
4. Mulcher Plug Note.(Inside Chute)
5. Side Discharge Chute