Removal and replacement procedures
15. If it is necessary to replace the display panel cable or display hinges:
a. Remove the two Phillips PM2.5×6.0 screws that secure the display panel to the display enclosure.
b. Lift the top edge of the display panel 1, and then swing it up and forward until it rests upside down in front
of the display enclosure.
c. Release the support strip 2 and locking bar 3 that secure the display panel cable to the display panel.
d. Disconnect the display panel cable 4 from the display panel.
e. Remove the display panel.
4–52
Maintenance and Service Guide