Creating A Video Conference (Multisite)—Ex90 Only - Cisco TelePresence EX60 User Manual

Cisco TelePresence System EX60 & EX90
Table of Contents
Creating a video conference
(MultiSite)—EX90 only
If your EX90 is equipped with the optional MultiSite
feature, you may call more than one to initiate a video
conference.
The MultiSite feature allows you to call three other
systems on video plus a fourth system on audio only
(for example a mobile phone).
This means that the conference can consist of up to
four video participants (yourself included) and one
audio participant.
If you want to initiate a video conference, you must
call each participant one by one.
Call settings. Those you call may have video systems
with different capabilities. One or more of them may,
for example, be on an ADSL system with limited
bandwidth (compared to the others). You may then
set the Call settings to a (normally lower) call rate
suiting his or her system before you call that person.
However, that call rate will affect that specific part of
the video conference only. Other participants will not
experience a lower call rate because of this.
D1501601 User guide EX60 & EX90
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. Version TC6.0, 01.2013
Getting started Video meetings Scheduled meetings
Place a call to the first
participant.
Call the next
participant in the usual
way.
Repeat the procedure from , if
needed.
A maximum four video systems
(yourself included) and one audio call
may participate.
If you initiated the conference you will be able to terminate the entire conference as well.
The other participants, however, may only disconnect themselves from the conference.
14
Managing Contacts The Settings
Once you are
in the call, tap Add.
Tap Add to place the second
call, initiating a conference. You
may adjust Call Settings before
you place the call, if needed.
Tap END to terminate the
conference.
User guide
www.cisco.com