Telnet - Bull 1GB Intel Ethernet Switch Module Installation And User Manual

Web Mode Specify whether the switch may be accessed from a web browser through TCP port
80. If you choose to Enable web mode you will be able to manage the switch from a
web browser. The factory default is Enabled.
Java Mode Enable or Disable the java applet that displays a picture of the switch at the top right
of the screen. If you run the applet you will be able to click on the picture of the
switch to select configuration screens instead of using the navigation tree at the left
side of the screen. The factory default is Enabled.
Click the Apply button to update the switch with new values. If you want the switch to retain the
new values across a power cycle you must perform a save.

Telnet

Use this panel to configure Telnet settings.
Telnet Login Timeout (minutes)
Specify how many minutes of inactivity should occur on a Telnet or SSH session
before the switch logs off. A zero means there will be no timeout. You may enter
any number from 0 to 160. The factory default is 5.
Maximum Number of Telnet Sessions
Use the pull-down menu to select how many simultaneous Telnet and SSH sessions
will be allowed. The maximum is 5, with 5 being the factory default.
Allow New Telnet Sessions
Indicates whether new Telnet sessions are allowed. If you set this to no, new Telnet
and SSH sessions will not be allowed. The factory default is yes.
Click the Apply button to update the switch with new values. If you want the switch to retain the
new values across a power cycle you must perform a save.
Web-Based Network Management
51