Virtual Local Area Network (Vlan) Commands; Config Vlan Bcaststorm; Config Vlan Create; Config Vlan Delete - Bull 1GB Intel Ethernet Switch Module Installation And User Manual

Virtual Local Area Network (VLAN) commands

config vlan bcaststorm

Use this command to enable or disable broadcast storm control for a particular Virtual Local Area
Network (VLAN). If broadcast storm control is enabled, storms are controlled by counting the
number of broadcast packets within a certain time period. If the [packets per second] count limit is
exceeded, the packets are discarded.
Default disable
Format config vlan bcaststorm <1-4094> <enable/disable> [packets per second]

config vlan create

Use this command to create a new VLAN and assign it an ID. The ID is a VLAN identification
number in the range of 2-4094 (ID 1 is reserved for the default VLAN).
Format config vlan create <2-4094>

config vlan delete

Use this command to delete an existing VLAN. The ID is a valid VLAN identification number. The
default VLAN cannot be deleted.
Format config vlan delete <2-4094>

config vlan makestatic

Use this command to change a dynamically created VLAN (one that is created by GVRP
registration) to a static VLAN (one that is permanently configured and defined) The number
identifies an existing VLAN.
Format config vlan makestatic <2-4094>

config vlan mcaststorm

Use this command to enable or disable multicast storm control for a particular VLAN. If multicast
storm control is enabled, storms are controlled by counting the number of multicast packets within a
certain time period. If the [packets per second] count limit is exceeded, the packets are discarded.
Default disable
Format config vlan mcaststorm <1-4094> <enable/disable> [packets per second]

config vlan name

Use this command to change the name of a VLAN. The name is an alphanumeric string of up to 16
characters, and the number identifies an existing VLAN.
Default The name for VLAN ID 1 is always Default. The default name for other VLANs is
a blank string.
Format config vlan name <name> <2-4094>

config vlan participation

Use this command to configure the degree of participation for a specific interface in a VLAN. The
number identifies an existing VLAN, and the parameter <port/listofports/all> indicates the port or
ports to be affected.
Format config vlan participation <exclude/include/auto> <1-4094> <port/listofports/all>
202
NovaScale Blade 1 GB Intel® Ethernet Switch Module: Installation and User's Guide