Table of Contents
Advertisement
This command and the config acl match srcl4port number command are two methods of
specifying the source layer 4 port range as a match condition. Either command can be used to
configure or modify the source layer 4 port range.
Format
config acl rule match srcl4port keyword <aclid> <rulenum> <portkey>
config acl rule match srcl4port number
Use this command to specify a packet's source layer 4 port match condition for the ACL rule
referenced by the <aclid> and <rulenum> parameters. The <startport> and <endport> parameters
identify the first and last ports that are part of the port range and have values from 0 to 65535. The
ending port must have a value equal or greater than the starting port. The starting port, ending port
and all ports in between will be part of the contiguous source port range.
Either this command or config acl match srcl4port keyword can be used to specify a source layer 4
port range as a match criterion.
Format
config acl rule match srcl4port range <aclid> <rulenum> <startport> <endport>
show acl detailed
Use this command to display an ACL and all of the rules that are defined for the ACL. The <aclid>
is the number used to identify the ACL.
Format
show acl detailed <aclid>
Rule Number
Displays the number identifier for each rule that is defined for the ACL.
Action
Displays the action that will be taken if a packet matches the rule's criteria. The
choices are permit or deny.
Protocol
Displays which IP protocol (if any) is a match condition for the rule. The possible
values are ICMP, IGMP, IP, TCP, and UDP.
Source IP Address
Displays the source IP address (if any) that is a match condition for this rule.
Source IP Mask
Displays the source IP mask (if any) that is a match condition for this rule.
Source Ports
Displays the source port range (if any) that is a match condition for this rule.
Service Type Field Match
Indicates whether an IP DSCP, IP Precedence or IP TOS match condition is
specified for this rule.
Service Type Field Value
Indicates the value specified for the Service Type Field Match (IP DSCP, IP
Precedence or IP TOS) if it a match condition for this rule.
show acl summary
Use this command to display a summary of the ACLs associated with interfaces in the system.
Format
show acl summary
ACL ID
Displays the ACL identifier.
Rules
Displays the number of rules that are associated with this ACL.
Interface(s)
Displays the interfaces associated with this ACL.
Command Line Interface Management
223
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the 1GB Intel Ethernet Switch Module and is the answer not in the manual?