Fuser Roller - Canon MF4600 Series Basic Operation Manual

Fuser Roller

If black streaks appear with printing, the
fuser roller in the main unit may be dirty.
Should this occur, clean the fusing roller
in the following procedure. The roller
should also be cleaned each time the toner
cartridge is replaced. Load a sheet of blank
A4 paper into the multi-purpose tray and
start cleaning.
– Cleaning the roller takes approximately 130
seconds.
– When some jobs are stored in memory, this
function is not available.
1
Press [Additional Functions].
2
Press [ ] or [
<ADJUST./CLEANING>, then press
[OK].
10-6
3
4
5
] to select
Load a sheet of blank A4 paper in
the multi-purpose tray.
Press [ ] or [ ] to select <FIX.
UNIT CLEANING>, then press [OK].
Press [ ] to select <YES>.
Cleaning starts. When finished, press [Stop/
Reset] to return to the standby mode.
– Use standard paper as the cleaning paper.
– Throw away the cleaning paper after use.