SYSTEM SETTINGS
8. POP PASSWORD
9. POP INTERVAL
8. STARTUP TIME SET.
6. COMMUNICATIONS*
1. COUNTRY SELECT
2. E-MAIL SETTINGS
1. MAX TX DATA SIZE
2. DIVIDED OVER MAX
3. FAX SETTINGS
1. TX START SPEED
2. RX START SPEED
3. R-KEY SETTING
4. MEMORY LOCK
* MF4690PL Only
Enters the password for access to the POP server (max. 32
characters).
Sets the interval you want the POP server to check for incoming
e-mail. If the interval is set to 0, the POP server is not checked
automatically (0MIN.–99MIN.).
Sets the time period required to delay the startup of network
communications for the machine (0SEC–300SEC).
Sets the fax and e-mail communication.
Select the country or area where the machine is used.
Sets the e-mail communications.
Sets the maximum data size for outgoing e-mail messages. If
the e-mail message exceeds this data size limit, it is split up into
several e-mail messages before being sent (0MB-99MB).
Sets whether to divide a document into separate files when it is
sent if its size exceeds the data size you specify.
–
OFF
–
ON
Sets the facsimile communication.
Sets the transmission start speed for faxes.
(33600bps, 2400bps, 4800bps, 7200bps, 9600bps, 14400bps)
Sets the reception start speed for faxes. (33600bps, 2400bps,
4800bps, 7200bps, 9600bps, 14400bps)
Registers the [R] key to access an outside line easily. (See
Chapter 4, "Sending and Receiving (MF4690PL Only)," in the
Reference Guide.)
–
PSTN
–
PBX (HOOKING/PREFIX)
Sets whether to receive and store all documents in memory
and not to print automatically. (See Chapter 4, "Sending and
Receiving (MF4690PL Only)," in the Reference Guide.)
12-41