Table of Contents
Advertisement
Initialize
You can reset [Distance] settings to the initial factory
settings.
1
Select [Initialize] under [Distance] in
[SPEAKER] menu.
2
Press~.
~
The confirmation screen appears.
3
Select [Yes] to reset the setting, and then press
ENTER.
~
[Distance] settings are reset to the initial factory
settings.
Setting speaker levels
You can set the volume levels for individual speakers.
•
Select [Level] in [SPEAKER] menu.
Front L, Center, Front R, Surround L, Surround R,
Subwoofer
Set the volume levels for front
UR
speakers, center
speaker, surround UR speakers or subwoofer.
Control range:
OdB
to
-12dB
Control step:
1dB
Test Tone
A test tone can be output to help you judge the volume
level of each speaker.
1
Select [Test Tone] under [Level] in [SPEAKER]
menu.
2
Press"'"
~
to select
[Off],
[Manual] or [Auto].
Off
Select this to output no test tone.
Manual
Select this to output the test tone manualIy.
Auto
Select this to output the test tone from each speaker
automaticalIy·
3
For [Auto], press .,.., ~ to select [Yes], and then
press
ENTER
to output the test tone. For
[Manual], press
~,~
to select each speaker,
and then press
ENTER
to output the test tone.
Note;i;i
• The test tone is not output from a center speaker, surround
speakers, and a subwoofer when the [Analog Output] setting is
set to [Stereo] (see "Setting the analog output" on page
31).
• These settings are only effective for analog output.
SETUP MENU
Initialize
You can reset [Level] settings to the initial factory settings.
1
Select [Initialize] under [Level] in [SPEAKER]
menu.
2
Press~.
~
The confirmation screen appears.
3
Select [Yes] to reset the setting, and then press
ENTER.
~
[Level] settings are reset to the initial factory
settings.
Setting the SA-CD configuration
You can select speaker sizes and on/off statuses for
SA-CD discs. You can also select a cut-off (cross-over)
frequency for all low-frequency signals. All frequencies
below the selected frequency are sent to the subwoofer.
•
Select [SA-CD] in [SPEAKER] menu.
SA-CD Config
Select speaker sizes and on/off statuses from the following
three settings.
SIze or on/off
Speaker
Config
1
Config
2
Config
3
Front UR
Large
SmalI
Large
Center
Large
SmalI
SmalI
Surround LlR
Large
Small
SmalI
Subwoofer
On
On
Off
CUT-OFF Frequency
Select a cut-off (cross-over) frequency for all low-
frequency signals. All frequencies below the selected
frequency are sent to the subwoofer.
Control range:
60, 80, 100, 120 (Hz)
33
En
Advertisement
Table of Contents
