Table of Contents
Advertisement
transmitted by the controller through RS-485 to a
computer.
Select the alarm data transmission mode as fol-
lows.
Off: The controller does not transmit alarm data to
the computer.
Auto 1: The controller relays alarm data every time
it receives data from the camera.
Auto 2: The controller transmits alarm data periodi-
cally to give the computer time to process the
latest data before receiving new data. Use this
mode if the computer takes time to process all
of received data.
1. Display the Communication Menu as shown in
Fig. 30 by repeating the previous procedures.
2. Move the cursor to the "Alarm Data" position
by pressing the Up (D) Switch or the Down
(C) Switch. Select the desired mode, "Auto 1",
"Auto 2" or "Off", by pressing the Right (B)
Switch or the Left (A) Switch.
To return to the Controller Set Up Menu, move the
cursor to the "Return" position by pressing the Up
(D) Switch or the Down (C) Switch then press the
Set Switch.
Note: For more details on the settings, refer to the
operating instructions of the connected equip-
ment.
7. Alarm Control
(1) Alarm Operation
When this unit receives an alarm from the camera,
such as Panasonic WV-CP610 is activated at
motion detect mode, or camera site receiver WV-
RC100 or WV-RC150, the Alarm Indicator blinks.
The indicator keeps blinking and "Alarm" is dis-
played on the monitor screen.
ALARM
RESET
Notes:
• "Alarm" display position can be placed at
upper or lower right side of the monitor screen.
Refer to the Title Setting on page 23 for setup
method.
• It is available to choose the "Alarm" display
mode on the monitor screen.
Refer to the Alarm Display Setting on page 27
for setup method.
-30-
Alarm
Advertisement
Table of Contents
