Panasonic WV-RM70 Operating Instructions Manual page 29

(3) Alarm Time Setting
1. Display the System Menu as shown in Fig. 27
by repeating the previous procedures.
2. Move the cursor to the "Alarm Time" position
by pressing the Up (D) Switch or the Down
(C) Switch, then select the desired alarm time,
0.5s - 120s, by pressing the Right (B) Switch
or the Left (A) Switch repeatedly.
(4) Alarm Display Setting
1. Display the System Menu as shown in Fig. 27
by repeating the previous procedures.
2. Move the cursor to the "Alarm Display" posi-
tion by pressing the Up (D) Switch or the
Down (C) Switch, then select either "On" or
"Off" mode by pressing the Right (B) Switch
or the Left (A) Switch repeatedly.
To return to the Controller Set Up Menu, move the
cursor to the "Return" position by pressing the Up
(D) Switch or the Down (C) Switch, then press the
Set Switch.
Camera ID
Cable Comp
Alarm Time
Alarm Display Off
Return
6-3. Communication Setup
1. Display the Controller Set Up Menu by repeating
the previous procedures.
2. Move the cursor to the "Communication" position
by pressing the Up (D) Switch or the Down (C)
Switch, then press the Set Switch to display the fol-
lowing display on the monitor screen.
** Controller Set Up **
System *
Communication *
Set up Enable
-27-
** System **
Off *
S
60 S
Fig. 28
** Communication **
Unit Number 1
Baud Rate 9600
Data Bit 8
B
Parity Check None
Stop Bit 1
Xon/Xoff Not Use
Wait Time Off
Delay Time Off
Alarm Data Off
Return
Fig. 29