Table of Contents
Advertisement
6-2. System Setup
1. Display the Controller Set Up Menu by repeating
the previous procedures.
** Controller Set Up **
System *
Communication *
Set up Enable
Fig. 19
2. Move the cursor to the "System" position by press-
ing the Up (D) Switch or the Down (C) Switch,
then press the Set Switch to display the System
Menu as shown in Fig. 19.
3. Move the cursor to the desired item by pressing
the Up (D) Switch or the Down (C) Switch and
then select the desired mode by pressing the Right
(B) Switch or the Left (A) Switch.
4. After completing the above settings, move the cur-
sor to the "Return" Position then press the Set
Switch to return to the previous Controller Set Up
Menu.
** System **
Camera ID
Off *
Cable Comp
S
B
Alarm Time
60 S
Alarm Display Off
Return
5. Press the Program (PROG) Switch to return to the
previous Program Menu.
To return to the normal camera picture, press the
Program (PROG) Switch again.
(1) Camera ID Setting
1. Display the System Menu as shown in Fig. 20
by repeating the previous procedures.
Camera ID
Cable Comp
Alarm Time
Alarm Display Off
Return
2. Move the cursor to the "Camera ID" position
by pressing the Up (D) Switch or the Down
(C) Switch, then select either "On" or "Off"
mode by pressing the Right (B) Switch or the
Left (A) Switch.
3. When the Camera ID needs editing, perform
the following steps by using the sub menu of
Camera ID.
-23-
** System **
Off *
S
60 S
Fig. 20
Advertisement
Table of Contents
