Table of Contents
Advertisement
3. Move the cursor to the desired item by pressing
the Up (D) Switch or the Down (C) Switch and
then select the desired mode by pressing the Right
(B) Switch or the Left (A) Switch.
4. After completing the above settings, move the cur-
sor to the "Return" position by pressing the Up (D)
Switch or the Down (C) Switch, then press the Set
Switch to return to the previous Controller Set Up
Menu.
5. Press the Program (PROG) Switch to return to the
previous Program Menu.
To return to the normal camera picture, press the
Program (PROG) Switch again.
(1) Unit Number Setting
1. Display the Communication Menu as shown in
Fig. 30 by repeating the previous procedures.
** Communication **
Unit Number
Baud Rate
Data Bit
Parity Check
Stop Bit
Xon/Xoff
Wait Time
Delay Time
Alarm Data
Return
Fig. 30
1
9600
8
None
1
Not Use
Off
Off
Off
2. Move the cursor to the "Unit Number" position
by pressing the Up (D) Switch or the Down
(C) Switch, then select the desired unit num-
ber, 1-16, by pressing the Right (B) Switch or
the Left (A) Switch repeatedly.
(2) Baud Rate Setting
1. Display the Communication Menu as shown in
Fig. 30 by repeating the previous procedures.
2. Move the cursor to the "Baud Rate" position by
pressing the Up (D) Switch or the Down
(C) Switch.
Select the desired baud rate, 1200 - 19200, by
pressing the Right (B) Switch or the Left (A)
Switch repeatedly.
(3) Data Bit Setting
1. Display the Communication Menu as shown in
Fig. 30 by repeating the previous procedures.
2. Move the cursor to the "Data Bit" position by
pressing the Up (D) Switch or the Down (C)
Switch.
Select the desired data bit, 7 or 8, by pressing
the Right (B) Switch or the Left (A) Switch.
-28-
Advertisement
Table of Contents
