Download Print this page
Panasonic WV-Q151C Operating Instructions Manual
Panasonic WV-Q151C Operating Instructions Manual

Panasonic WV-Q151C Operating Instructions Manual

Ceiling mount bracket
Hide thumbs Also See for WV-Q151C:

Advertisement

Quick Links

Ceiling Mount Bracket

Operating Instructions

WV-Q151C/WV-Q151S
Model Nos.
Before attempting to connect or operate this product,
please read these instructions carefully and save this manual for future use.
No model number suffix is shown in this manual.

Advertisement

loading

Summary of Contents for Panasonic WV-Q151C

  • Page 1: Operating Instructions

    Ceiling Mount Bracket Operating Instructions WV-Q151C/WV-Q151S Model Nos. Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. No model number suffix is shown in this manual.
  • Page 2 This bracket can be used for an area with weak pull-out strength such as plasterboard in a double ceiling. This bracket is an embedded type to reduce the exposed portion of the camera body. • WV-Q151C: Clear dome cover • WV-Q151S: Smoked dome cover (approx. 50 % of transmittance) Precautions •...
  • Page 3 • Select an installation area that can support the total weight. If a selected area is too weak to support the total weight, a fall of the product may occur resulting in injury. Installation work shall be started after sufficient reinforcement. •...
  • Page 4 Major Operating Controls and Their Functions Mounting base Fixing screw to be used for cover fall prevention Hole for microphone cable Microphone stand* * If a microphone is used, mount the microphone on the rubber-made microphone stand. Unless the microphone is used, cut the rubber with a nipper or conduct another treatment. <Installation sample>...
  • Page 5 Installations Be sure to read "Precautions" on the page xx before installation. The Installation Guide of the network camera, WV-NS202, shall be read as well. 1. Remove the decorative cover. q Loosen the fixing screw (unremov- able) to be used for cover fall pre- vention.
  • Page 6 3. Put Template A (accessory) against the ceiling and make a hole. q Make 4 holes of 12 mm {1/2"} in diam- eter. w Remove the center part from the tem- plate. e Make a hole of 160 mm {6-5/16"} in diameter.
  • Page 7 5. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe- ty wire (accessory) to the angle. q Disconnect the safety wire from the safety wire angle. w Engage the face marked q with the anchor bolt.
  • Page 8 7. Insert the mounting base into the hole made in Step 1. 8. Secure the mounting base to the ceil- ing board with the ceiling board fixing screws (4 positions). q Engage the top of the mounting base with the 1st anchor bolt. w Secure the mounting base by turning the ceiling board fixing screws clock- wise.
  • Page 9 10. Install the inner shell. Slide the covers located on the both lat- eral sides of the camera and put the inner shell on the camera until the hooks inside the inner shell are held in the holes of the camera (until a click is heard).
  • Page 10 11. Mount the camera on the camera mounting plate. q Put the camera onto the camera mounting plate with aligning the lock plate of the camera with the guide of the camera mounting plate and aligning the center of the camera mounting plate with the center of the screw for tripod mounting, and turn the camera clockwise.
  • Page 11 Turn the decorative cover clockwise while pressing upward and the cover is locked. Important: The mark, "FRONT", shall be aligned with the Panasonic logo. 16. Tighten the fixing screw to be used for cover fall prevention. (Recommended tightening torque: 1.6 N·m {16 kgf·cm}) Note: When the camera lens is pointed in the horizontal direction, the inner shell interferes with the camera’s view, and consequently about upper half of the monitor screen is...
  • Page 12: Specifications

    Template B ... 1 sheet Inner shell ... 1 pc. For U.S., Canadian and Puerto Rican fields: Panasonic System Solutions Company, Unit Company of Panasonic Corporation of North America Security Systems www.panasonic.com/security For customer support, call 1.877.733.3689 Executive Office: Three Panasonic Way 2H-2, Secaucus,...

This manual is also suitable for:

Wv-q151s