Table of Contents
Advertisement
4 - Troubleshooting the SAGEM F@st
4.3.6
All LEDs lit
This state indicates that the software has not been correctly downloaded from the PC to the
modem. This may happen if the installation procedure is interrupted before it is finished.
Proceed as follows :
! Disconnect then reconnect the USB cable between the PC and the modem.
If the modem still doesn't start up :
! Disconnect then reconnect the power cable from the modem.
If the problem remains, uninstall the drivers and restart the installation of the software as
described in § 4.1.
4.4
No access to the wide area network
The LEDs should indicate that your equipment is operating normally:
PWR
Green, on steady Green, on steady
! If they do, a link is theoretically set up between your SAGEM F@st™ 1000 and the wide
area network.
! If not, refer to section 4.3.
However, you may have problems accessing a WEB page or a remote machine.
User Guide - N56815740110
Page 4-8
eproduction or communication without the written consent of SAGEM SA
No r
TM
1000 modem
LINE
USB
Green, on
steady
DATA
Green, blinking
(with data)
Off
(without data)
Advertisement
Table of Contents
