Table of Contents
Advertisement
4.3.1
"PWR" LED off
This state indicates that the SAGEM F@st
! Check for mains voltage at the power outlet.
! Check that the mains adapter unit is correctly connected to the mains outlet and that the 4-
way MINI-DIN connector terminating the cable from the unit is correctly plugged into the
PWR socket on the SAGEM F@st
4.3.2
PWR indicator blinking continuously
! Contact the supplier of your SAGEM F@st™ 1000 modem.
4.3.3
"LINE" LED blinking
This means that the SAGEM F@st™ 1000 is trying to connect to the remote exchange. This
indicator remains in this state until the modem is connected to an active ADSL line.
ADSL connection takes under one minute after connecting the ADSL line.
! If, however, after the connection time, the LED is still blinking:
• Check that the SAGEM F@st™ 1000 is correctly connected to the ADSL line (either
directly or via a splitter or via a microfilter).
• Check that the pins of the RJ11 connectors are neither soiled nor damaged.
• Check with your Service Provider that the ADSL mode is indeed activated on the
telephone line that you want to use.
• Check with your Service Provider that the ADSL link provided on the line is compliant with
one of the three transmission standards supported by the SAGEM F@st™ 1000:
- ANSI T1.413 I2,
- G.992.1 (G.dmt),
- G.992.2 (G.lite).
4.3.4
"USB" LED off
! Check that the Type B/Type A USB cable is connected to your computer.
4.3.5
"DATA" LED off
! Check that the SAGEM F@st™ 1000 is correctly connected to the ADSL line (LINE LED lit).
! Check that the pins of the RJ11 connector are neither damaged nor worn.
! Check with your Internet Access Provider that the ADSL mode has been activated on the
telephone line that you want to use.
eproduction or communication without the written consent of SAGEM SA
No r
4 - Troubleshooting the SAGEM F@st
TM
1000's internal DC power supply is not functioning.
TM
1000 unit.
TM
1000 modem
User Guide - N56815740110
Page 4-7
Advertisement
Table of Contents
