2.3
Installation procedure
This section summarizes the procedure when installing the SAGEM F@st™ 1100 for the first
time.
! Check the compatibility of the mains supply with the SAGEM F@st™ 1100.
! Check with your Operator to ensure that the ADSL line is available.
! Check with your Access Provider to ensure that your subscription is valid.
! Install the drivers of your SAGEM F@st™ 1000.
! Connect the SAGEM F@st™ 1000:
• to the mains supply,
• to the remote network via an ADSL compatible telephone line,
• to your computer via USB interface.
! Check that the connections have been correctly made, as indicated by the four LEDs on the
SAGEM F@st™ 1000. The required LED states will depend on whether the USB or Ethernet
mode is used:
PWR
Green, on steady Green, on steady Green, on steady Green, on steady
This table shows the state of the LEDs before connecting the USB cable (see chapter 3 for
details).
! Finish the installation of your modem.
eproduction or communication without the written consent of SAGEM SA
No r
2 - Connecting the SAGEM F@st™ 1000
LINE
USB
DATA
User Guide - N56815740110
Page 2-7