Ice Cube Container; Drip Tray - Miele F 1472 Vi Operating And Installation Instructions

Frost-free freezer with ice/water dispenser
Hide thumbs Also See for F 1472 Vi:
Table of Contents

Advertisement

Cleaning and care
Aluminium frames
The frames on the shelves inside the
appliance and on the door baskets are
made from aluminium.
Aluminium is affected by the way that
light falls on it, by the surrounding
environment and by the angle you
observe it from.
It is susceptible to scratching.
The aluminium frames may suffer
discolouration or damage if soiling is
left on for too long. Remove any
soiling immediately.

Ice cube container

^ Pull the ice cube container out of the
appliance.
^ Empty it and rinse it with hot water.
^ Dry the container and spindle
thoroughly so that new ice cubes will
not freeze onto the surfaces.
To replace the ice cube container
^ Push it back into the appliance until it
clicks into position.
^ If you cannot push it back in all the
way, turn the spindle inside a little.
42

Drip tray

The drip tray catches excess water.
When the drip tray is full, the
in the ice/water dispenser control panel
will flash and dispensing will stop.
There are sensors in the drip tray which
measure when the drip tray needs to be
emptied.
To avoid a build-up of odour, the drip
tray should be cleaned every day.
When the
symbol flashes,
^ remove the drip tray cover and the
grille underneath it.
^ Mop out the drip tray using a sponge
or tea towel and then clean it.
^ Clean the drip tray cover and the
grille.
^ Replace the grille and the drip tray
cover.
The
symbol will now be highlighted in
white again.
symbol

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents