Switching On The Ice/Water Dispenser - Miele F 1472 Vi Operating And Installation Instructions

This will activate the rinsing function:
Approx. 6 litres of water will now be
pumped through the pipework.
You can interrupt the rinsing process at
any time to allow you to empty the
container by taking your finger off the
sensor for chilled water.
The sensor will continue to flash yellow
while you empty the container.
A beep will sound when the rinsing
process is complete and the sensors in
the ice/water dispenser control panel
will now be highlighted in white.
The ice/water dispenser is now ready
for use.
Switching on the ice/water
dispenser
Rinse the ice/water dispenser
pipework before using it for the first
time (see "Before using the ice/water
dispenser for the first time").
^ Open the appliance door.
^ Make sure that the ice cube
container is correctly located
underneath the ice/water dispenser.
The ice cube container must be
completely shut for ice cubes to be
produced.
^ Touch the On/Off sensor for the
ice/water dispenser to highlight it in
yellow.
Ice/water dispenser
^ Close the appliance door.
The ice/water dispenser is now ready to
use.
It may take a few seconds after
opening and closing the appliance
door before the sensors can be
used and the ice/water dispenser is
ready for use.
^ Activate the ice/water dispenser by
touching one of the sensors or waving
your hand briefly under the dispenser
spout. A light sensor below the spout
will register this movement.
All the sensors in the ice/water
dispenser control panel should now be
highlighted in white.
If this is not the case, the system lock
has been activated (the
highlighted in yellow, see "System lock").
If the sensor is flashing, the drip
tray needs to be emptied (see
"Cleaning and care").
Once the freezer has cooled down to its
set temperature, the ice cube maker will
fill with water.
Do not place bottles or other items in
the ice cube maker to chill them
quickly. The ice cube maker could
become blocked and, as a result, be
damaged.
sensor will be
35