Waypoint Mode - Schwinn 810 User Manual

ALERT Sub mode:
Press S5 to enter ALERT function. When alert is set to ON, there will be a beep sound during
taking auto lap. When it is set to OFF, there is no beep sound. Default is ON.
GO BACK Sub mode:
Press S3 to enter GO BACK function. The current exercise will be save first then 3 seconds
auto, the chronograph will start and you will start going back to the starting point of the
exercise.
START/STOP Sub mode:
Press S5 to stop the chronograph.
SCALE sub mode:
Press S3 to select the scale range. Scale range is selectable by pressing S1 or S5. Press S7
to exit without saving. Press S3 to save the selection and exit. The default scale is AUTO
scale. The available selections are: AUTO, 50 m, 100m, 200m, 400m, 800m, 1.6KM, 3.2Km,
and 6.4Km.
SAVE sub mode:
Press S5 to save the current Run exercise. The watch will go back to reset view after saving
and ready for the next exercise.
DELETE sub mode:
Press S5 to delete current Run exercise. The watch will go back to reset view after saving
and ready for the next exercise.
EXIT sub mode:
Press S3 to exit sub mode.

WAYPOINT mode

Press S7 from Run Data mode to enter Waypoint mode. In Waypoints mode, Press S3 to
choose your saved waypoint. Press S1 / S5 to select or view various waypoints in memory.
The "DELETE" selection will display after the last waypoint. Press S3 to delete all Waypoints.
The watch will ask for your confirmation, YES or NO. Press S1/S5 to choose, Press S3 to
CONFIRM.
Going to your saved WAYPOINT
At Waypoint Mode, Press S1 / S5 to select a desired Waypoint. Press S3 to choose a
waypoint. After pressing S3 you will be prompted with GOTO / EDIT / DELETE options.
Press S1 / S5 to scroll thru these options. Press S3 to confirm. If there is no GPS signal, the
user cannot use the GOTO waypoint function.
Choose GOTO to start your exercise. You will be going from your current location to the
coordinates of the selected Waypoint.
Choose EDIT to change the name of the saved Waypoint.
Choose DELETE to delete the selected Waypoint.
GOTO function:
1. Press S3 to confirm start after selecting the GOTO function. Chronograph will start
running. 2 seconds later, the watch will the remaining distance to your destination and
the chronograph time. 3 seconds later, the watch will display the electronic map of your
current location and destination.
2. Press S11 to change views. The views when you press S11 are the same views in RUN
modes except for View 1 and View 2
3. Upon selecting your view, you have started your exercise. Press S1 to take Lap, When
Auto lap is ON, the watch will automatically take lap. . You will also hear 2 seconds
beep sound.
4. Press S5 to stop. While chronograph is stopped, press S5 to save data. When memory
is full, the data will have "First In, First out".
BD26