Schwinn 810 User Manual page 8

If you press S11 to change views, the watch start searching for HR signal and display views
with HR. After 2 minutes without HR signal, it will automatically change to Chronograph view
w/out HR.
When you enter Run mode and the GPS signal is not yet received, the watch will display
LOCATING SATELITE.
While in Run mode, then the GPS signal suddenly becomes weak for any reason, the
watch will display LOST GPS RECEPTION until it receives GPS signal again.
In Run mode without HRM, calorie is calculated when speed is less than 25Km/hour.
Performance specs:
- Maximum of 60 hours track record can be saved in memory.
- Total of 25,000 track points. Track point sampling time is 5 sec.
- If track record is full, the oldest data will be overwritten.
- Maximum of 50 data files for Run mode
- Maximum of 300 laps for each data files
- Speed range: 0- 199.9 km/h (mph)
- Distance range: 0- 9,999.99 Km (Mile)
- Heart rate range: 30- 240 BPM
- Chrono range: 00:00"00 – 99:59'59"
- Calorie range: 0 – 99,999 Kcal
RUN Sub-modes:
While in RUN, GOTO waypoint, GO BACK, and GOTO modes, press S3 (if EL is ON) or
double press S3 (if EL is OFF) to enter the sub modes. Press S1/S5 to scroll through the
various sub-modes. Press S7 to go back Main Screens of RUN, GOTO Waypoint, GO BACK
and GOTO. The following are the views of sub-modes:
AUTOLAP
NIGHT
ALERT
GOBACK
START/STOP
SCALE
SAVE
DELETE
EXIT
If no key operation, after 1 minute, the watch will automatically exit to previous main view.
AUTOLAP sub mode:
You can use auto lap to automatically take the lap at specific traveled distance. This setting is
helpful for comparing your performance over different part of the RUN.
To set the Auto lap:
1. Press S3 to set the Auto lap.
2. Press S1/S5 to select the various settings. Following are the auto lap preset range: OFF,
0.5 Km, 1 Km, 2 Km, 3 Km, 4 km and 5 Km. Default value is 1.0 KM.
3. Press S5 to save the selection and exit.
NIGHT sub mode:
Press S3 to enter Night sub mode. Press S1/S5 to Select Night ON or OFF. When you select
ON, pressing any button will activate the EL backlight for 5-6 seconds from 6 pm to 7 am.
When you select OFF, Press S5 will turn on the EL backlight. Other buttons will have no light
function. Default value is ON.
BD26