Schwinn 810 User Manual page 10

At the lower right side of the screen, there is an icon to signify you are in GOTO function, or
you have exceeded or going away from your destination.
If there is no GPS signal, or the Run is running, you cannot use the GOTO function.
When you arrived at your destination, the watch will display 'ARRIVED DEST".
Saving your WAYPOINT
1. Press and hold S11 for 2-3 seconds from any view then release. The watch will display
the locations' coordinates (Latitude, longitude, and Altitude). 3 seconds later it will
prompt the user to save the location. The default name of the saved waypoint is the
date of Time 1. The format is MMDDXXX. The first 2 digits are for the month, the
second 2 for the day, and XXX is for the unique number for the day.
2. Press S1/S5 to edit individual digits. You can edit the location name up to 7 digits.
3. Press S3 to set the next digit.
4. Press S7 to exit setting mode. If there is no key operation for 5 seconds, the watch will
auto exit to previous view. After saving the location name, it will be saved in the
Waypoints list. Maximum of 200 locations can be saved in memory.
When the user is saving the waypoint and the watch is not receiving the GPS signal, it will
display "GPS NOT AVAILABLE".
RUN DATA MODE
Press S7 from Run mode to enter Run DATA mode. The watch will display the Data list view.
In this view you can see how many files are saved in RUN data. The watch will show the list
of data files with newest on the top of the list.
1. Press S1/S5 to scroll thru the list.
2. Press S3 to enter the selected data file. Press S7 to exit.
3. Press S1/S5 to view the details of the data file. Following are the details available:
Start/ End Time
Speed Data (Exercise time/ Distance/ Ave Speed/PACE/ HR)
HR Data (Exercise time/Ave HR/ Max HR)
Track map – If the saved data has Track + Data- this will be shown. If Data Only file,
this map will not be shown.
Lap 1 Time/ Distance/ ave speed / ave HR
Lap 2 Time/ Distance/ ave speed / ave HR
Lap 3... ETC...
4. Press S7 to exit
If there is no key operation within 20 minutes in this mode, the watch will auto exit to Time
mode.
Data numbering system/ Legend:
Following is the data numbering system.
Sample data number: 0704102 G
07 - Month
04 - Day
1 - Data is referred to Time 1 or 2 for Time 2
02 - File number of the day
G - Data with track (if replaced with H- data w/out track)
Data mode Sub modes
Press S3 from any view in Data mode to enter the sub modes. Following are the sub modes:
GO BACK
GOTO
VIEW
EDIT
DELETE
EXIT
Press S1/S5 to scroll thru these sub modes.
BD26