SCREW DOWN CROWN [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight.
Page 3
2 Turn in the desired direction to set the time. 3 Push back in to normal position in accordance with a time signal. TIME/CALENDAR SETTING FOR CAL. Y302 CROWN 1 Pull out to the first click. 2 Turn until the previous day’s date appears in the calendar frame.
Page 4
4 Turn until the desired date appears. * Turn Crown to advance Hour and Minute hands. 5 Turn in the desired direction to set the time. 6 Push back in to normal position in accordance with a time signal. NOTES: Do not set the date between 9:00 p.m.
Page 5
When the battery expires, be sure to replace it as soon as possible to prevent any malfunction. We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement. WARNING Do not remove the battery from the watch.
Page 6
Loss/gain in normal temperatures of between 5 C ~ 35 C (41 F ~ 95 F). Annual rate : Approximately 10 seconds (Cal. Y301) / 20 seconds (Cal. Y302) when used on the wrist approximately 12 hours a day. Monthly rate : 2 seconds (Cal.
Page 7
year. The amount of loss/gain fluctuates depending on the condition of use as shown in the figure below. Annual rate specifies the range of loss/gain that is never exceeded at any given time of a year. Examples of monthly fluctuations of loss/gain: In case of a watch with the yearly loss/gain of 10 seconds (sec.) Gain...
WATER RESISTANCE Non-water resistant • If the watch becomes wet, have it checked by an AUTHORIZED PULSAR DEALER or SERVICE CENTER. Water resistant 5/10/15/20 bar • Before using in water, be sure the crown is pushed in completely. • Do not operate the crown when the watch is wet or in water.
Page 9
Care should also be taken on diving into water. ** We recommend that you wear a PULSAR Diver’s Watch for scuba diving. TEMPERATURES MAGNETISM...
2 to 3 years. Have Years watch or hit it against hard your watch checked by an surfaces, as this may AUTHORIZED PULSAR cause damage. DEALER or SERVICE CENTER to ensure that the case, crown, gasket CHEMICALS and crystal seal remain intact.
Need help?
Do you have a question about the Y302 and is the answer not in the manual?
Questions and answers